Last weekend, I pulled the Sniper out of the engine bay and tucked it safely away in a box in the garage. The mechanical fuel pump is back on the truck, but it gave me a fight the last couple of days—it wouldn’t prime, and it sits uncomfortably close to the engine mount. Thursday morning I bypassed it with an electric pump and fed the carb directly. Once it fired, the engine tried to run away on me, so I reset the mixture screws to baseline. That’s when I found a huge vacuum leak at the back of the carb. After sealing that up, it settled into a decent idle. I set timing back to about 10°, which feels a lot more reasonable, dropped the hood, and took it for a spin around the block. The choke cable still needs to be hooked back up, but once it warmed up it drove fine. Heavy throttle still causes it to bog, so there’s more tuning ahead, but it’s already a big improvement.
I do want to pull the electric fuel pump off. Now that the lines are primed I want to hook the mechanical back up and see if it will pull fuel; if not, I’m going to pull the trigger on a rebuild kit for the original unit, which fits the truck better in any case.
Meanwhile, I painted the new plywood panel for the rear bed with a marine oil-based primer, countersunk the bolt holes, and rolled on two coats of Raptor Liner front and back. I have some fresh hardware in hand to put it in more permanently, although I have to go back out to get more bolts—the ones they used are an odd thread count for their size.
Lastly, I tore down a spare rear door to salvage the good glass, cleaned the tracks, and swapped it into the red truck. Once I knew the steps, the job was quick and straightforward. While I had the door apart, I pulled the handle, chased out a bit more rust, skimmed it, and gave it a fresh coat of paint.