Saturday morning I waited until it stopped snowing to get bundled up in work clothes to go take care of a bunch of truck stuff. My sister bought me a set of Redkap coveralls for Christmas, which, like all other work/utility brands were my correct measurements but cut for someone four times my size. We did some re-configuring and I traded up to a set of Dickies bib overalls which are a bit heavier, and I’m very pleased with how they fit—and they’re plenty warm too. Thanks Renie!
The first order of business was to see if the engine in the 800 had loosened up. I pulled the spark plug in cylinder 1, which is the only one still holding liquid, and found that it was still full. I decided I wanted to make life easier on myself, so I drained and pulled the radiator out, freeing up a ton of space so that I could put the breaker bar/pipe combination directly on the crank bolt without having to crawl in the mud under the truck. This was remarkably easy; the four bolts holding the rad/shroud combination came right out, and all I had to do was pull the crosswise support rods out to get it past the cooling fan. With that out of the way, there was suddenly all kinds of room to move in there.
The engine, however, would not budge. It’s been sitting for two weeks with ATF/acetone down each cylinder, and there has been no change. I’m happy to play the long game right now though before I go to the nuclear option and decide to pull the head off—there’s plenty more to do. I’ll just keep going out there and yanking on it every couple of days.
Over on the Travelall, I jacked the passenger side up and made pretty short work of pulling the front spring pack out. Back in the warm garage, I wire-wheeled the packs and mounting plates and sprayed the latter with some Rust-Stop before it got too cold. I had MLK Day off from work, so I drove into Baltimore and dropped them off at the shop where I had the rears done.
Meanwhile I’ve been gathering the parts to put in a working dome light, and I think I’ve got a plan put together. One of the first things I needed were special clips for two of the headliner bows, which I found at our local ACE hardware, and they fit perfectly in the factory channels. With all five bows in place, I now have something to hang dome lights from. I started the wiring part by looking at the factory diagram and realizing I’d perhaps missed one of the pins on the light switch, so I pulled the switch out, hosed it off with electric degreaser, and noticed that the copper contact on the rheostat for the dome light had broken off at some point in the past. I pulled the switch from the green truck dashboard, cleaned it up, and put it in DH. With the system wired up as I understood it from the diagram, I still wasn’t able to get light from the switch, and when I tried to stub in a door switch I blew the fuse.
About that time I got a call from the spring shop, who told me it was ready for pickup. Pleasantly surprised, I drove back into the city, paid them cash (I don’t sneeze at a $50 discount) and returned home with my updated spring packs. By then it was too dark to continue outside, so I stored them in the garage and called it a night.
I’ve been outside as much as possible, but the weather has been lousy for a while now so I moved to some indoor projects. When I pulled the steering column out of the truck in Pittsburgh, I got a basic tw0-spoke steering wheel as part of the deal, which matches the one in the 800. I pulled out the two-part epoxy I used on the steering wheel project last year. This wheel was sun-baked and cracked but not nearly as bad as the first one. With two rounds of epoxy and sanding, I’ve got it mostly ready for primer and paint.
Finally, Brian handed off a couple of new 3D prints of my dealer badge from a guy on his side of the bay who offers ABS as one of the options; ABS is much more temperature-resistant than the PLA prints I got at the library. I’m thrilled with the results, but I’m going to see if he can increase the size for me.