I was away for most of the last week and a half, but I did get some time before we left to rough in the new brake line I was sent by the Scout Connection a few weeks ago. Saturday afternoon after we returned, I got tired of laying around the house and decided to go out and finish welding up the patch I’d started two weeks ago. Overall it went pretty well; I think I would have done it completely differently in hindsight, and I bet I’ll have to go back and cut it out at some point, but for now it’ll hold.
On Sunday I wanted to tackle the biggest hurdle the project has thrown at me so far: bleeding the brakes. I bled the master cylinder and hooked it up to the main lines, then had Finley come out and pump the brakes for me while I opened the line on the rear wheel. When nothing happened where I was, I looked underneath and realized the system was leaking at the distribution block: I hadn’t gotten it connected correctly. So I jacked the whole front end up and got underneath to really diagnose the situation, and after staring at it for a while I sorted out what was going on: I hadn’t tightened the soft line down enough to the block. So I disconnected it at the master cylinder and spun the whole hose to really tighten it down. With that done I hooked everything back up and had Finn pump the brakes on all four corners while I bled dirty brake fluid out of the lines. When I’d gotten that done, I put the wheels back on and lowered it to the ground. Then we did the clutch system and got that bled out. With that, the brakes should be 90% done. I’ll have to re-bleed them at some point in the near future to get the last bubbles out, but it’s enough to stop the truck once I get the clutch issue sorted out. It’s been a long learning process, but I sure hope I don’t have to deal with brakes again for a while.
While I had two wheels off the ground, I took the opportunity to swap the fourth rim to the driver’s front and put one of the original three on the back rear. What I found kind of shocked me: the original rim sits the same distance away from the inner edge of the wheel tub as the new rim did. The only difference between the new rim and the others is that the holes for the wheel studs are thicker and the studs don’t extend through as far as the others, which means there isn’t as much of the lug nut on the stud. I think I’m going to invest in a set of ET (extra thread) lug nuts for the whole truck—I just need to find someone who has 5 left-turn nuts in the size I need.